|
Installation
Parts: Tub, Base, four Metal Plates with Wood Blocks, Stainless Steel Screws
with Plastic Anchors, Silicone, and Acrylic Screw Cover Tabs.
1) Position base
on floor and mark position.
2) Place the four bolt plates inside the tub with wooden backs towards the four
corners and the metal L-plates resting on the floor.
 
3) Using the stainless steel screws provided screw the base to frame.
4) Using heavy-duty
fixings (included), tightly fix the metal plates to the floor.
 
5) Acrylic corner tabs are provided to cover the head of each exterior screw.
5) Place tub onto the base to ensure correct position and mark center of waste
outlet onto the floor.
6) Remove the tub and fix waste pipe work.
7) Fix the K12 waste to the tub and test for leaks prior to final installation.
8) Hold the tub above the base and connect the p-trap to the pipe work using
a length of flexible waste pipe and test for leaks.
9) When you are confident there are no water leaks raise the tub off the base
and apply a continuous silicone bead to the base.
10) Lower the tub onto the base and remove excess silicone.
11) Please allow 12 hours before using the tub for the first time.
* Once the silicone
seal is applied, the base and tub cannot be separated. To access the waste you
will have to unscrew the base from the frame and remove the complete bath.
Sorrento Japanese Soaking Tub
|
